- Precision laser pre-cut adhesive-backed wrap.
- Peel and stick application. If you can apply a sticker, you can install these wraps.
- Easy to install, allows for removal and repositioning on initial application without any loss of adhesion.
- Non-permanent and completely reversible.
3M VHB (Very High Bond) adhesive backing.
Please be aware that the camouflage pattern received may vary and is randomized. The variation and placement of camouflage material you receive can vary from piece to piece.
Installation Instructions:
• Step 1: Begin by thoroughly washing your hands with soap and water to ensure no contaminants interfere with the adhesion of the 3M adhesive to your product.
• Step 2: Utilize the provided alcohol swab to wipe down the entire surface of your product, ensuring it is clean and dry before proceeding.
• Step 3: Carefully remove the backing from the wrap to expose the adhesive. For optimal handling, consider using flat-tip tweezers.
• Step 4: Choose a suitable starting point, preferably a straight edge or cut-out, to facilitate proper alignment.
• Step 5: Gradually apply the wrap, gently pressing it into place from one side to the other. During this process, the wrap can be easily adjusted and repositioned as necessary for precise placement.
• Step 6: Once satisfied with the placement, firmly press down on the Cordura material across the entire surface of your product. The 3M adhesive requires pressure and time to fully activate, typically taking approximately 24 hours to cure once firmly applied.